Table of Contents
Advertisement
Procedure
(continued)
Enable to enter
your IP address
2.5 Check to enable Internet Protocol (TCP/IP) then click on the Properties
button.The following screen will appear:
2.6 Select Use the following IP address to set up the IP in a range compatible
with the range of the 61000. Once you click on the radio button, the fields
to enter the IP address and Subnet mask will be enabled.
•If this is an uninstalled system where the IP of the 61000 has not been
configured by the user, use the default settings shown below.
Default Settings:
•If the IP is already configured on the 61000, then the first three sets of
digits of the IP must be the same. The last set of number should be in the
range of 1 to 255, but not the identical number as the 61000.
2.7 When done configuring the IP address, click on the OK button.
Chapter 4/ Operational Description
IP Adress
192.168.0.5
Subnet Mask
255.255.255.0
Enter default IP
address: 192.168.0.5
Enter default Subnet
mask: 255.255.255.0
Continued on next page
4-9
Advertisement
Table of Contents
