EPOX EP-MVP3G-M User Manual page 39

EP-MVP3G-M/2/5
IDE Secondary Master UDMA: This allows you to select the mode of operation
for the hard drive. The default is Auto.
Auto : The computer will select the optimal setting.
Disabled : The hard drive will run in normal mode.
IDE Secondary Slave UDMA: This allows you to select the mode of operation
for the hard drive. The default is Auto.
Auto : The computer will select the optimal setting.
Disabled : The hard drive will run in normal mode.
Init Display First: If two video cards are used (1 AGP and 1 PCI) this specifies
which one will be the primary display adapter. The default is PCI Slot.
PCI Slots : PCI video card will be primary adapter.
AGP : AGP video card will be primary adapter.
Onboard FDC Controller: The default value is Enabled.
Enabled : Enable the Onboard floppy drive interface controller.
Disabled : Disable the Onboard floppy drive interface controller, When using
On-card ISA FDC's controller.
Onboard Serial Port 1: This field allows the user to sellect the serial port. The
default value is 3F8H/IRQ4.
COM1: Enable Onboard Serial port 1 and address is 3F8H/IRQ4.
COM2: Enable Onboard Serial port 1 and address is 2F8H/IRQ3.
COM3: Enable Onboard Serial port 1 and address is 3E8H/IRQ4.
COM4: Enable Onboard Serial port 1 and address is 2E8H/IRQ3.
Disabled: Disable Onboard Serial port 1.
Onboard Serial Port 2: This field allows the user to sellect the serial port. The
default value is 2F8H/IRQ3.
COM1: Enable Onboard Serial port 2 and address is 3F8H/IRQ4.
COM2: Enable Onboard Serial port 2 and address is 2F8H/IRQ3.
COM3: Enable Onboard Serial port 2 and address is 3E8H/IRQ4.
COM4: Enable Onboard Serial port 2 and address is 2E8H/IRQ3.
Disabled: Disable Onboard Serial port 2.
BIOS
Page 4-17