EPOX EP-MVP3G-M User Manual page 34

BIOS
Soft-Off by PWR-BTTN: Use this to select your soft-off function.
The default is Delay 4 sec.
Instant Off:
Delay 4 Second : Turns off after a 4 second delay. If momentary press of
This mainboard supports HDD Power Down, Doze and Standby power saving
functions when using the Intel Pentium II Processor. The default is Disabled
HDD Power Down: HDD Standby timer can be set from 1 to 15 minute(s).
Doze Mode: The "Doze" mode timer starts to count when no "PM events" have
occurred.
Suspend Mode: This function works only when the Pentium II Processor is
installed. The timer starts to count when "System Standby" mode timer is timed
out and no "PM Events" are occurring. Valid range is from 1 minute up to 1 hour.
VGA: When set to On (default), any event occurring at a VGA port will awaken a
system which has been powered down.
LPT & COM: When set to On (default), any event occurring at a COM(serial)/
LPT (printer) port will awaken a system which has been powered down.
HDD & FDD: When set to On (default), any event occurring at a hard or floppy
drive port will awaken a system which has been powered down.
DMA/master: When set to On (default), any event occurring to the DMA
controller will awaken a system which has been powered down.
Modem Ring Resume: When set to Enabled, any event occurring to the Modem
Ring will awaken a system which has been powered down.
RTC Alarm Resume: When set to Enable rta alarm resume, you could set the
date (of month) and timer (hh:mm:ss), any event occurring at will awaken a system
which has been powered down.
Page 4-12
Turns off instantly.
button, the system will go into Suspend Mode. Press
again to take system out of Suspend Mode.
EP-MVP3G-M/2/5