EPOX EP-MVP3G-M User Manual page 27

EP-MVP3G-M/2/5
Note that there will not be any warning message if the drive installed is
360K.
Boot Up NumLock Status: The default value is On.
On : Keypad is number keys.
Off : Keypad is arrow keys.
Gate A20 Option: This refers to the way the system addresses memory above
1MB (extended memory). The default value is Fast.
Normal: The A20 signal is controlled by keyboard controller or chipset hardware.
Fast : The A20 signal is controlled by Port 92 or chipset specific method.
Typematic Rate Setting: This determines the typematic rate.
Enabled : Enable typematic rate and typematic delay programming.
Disabled: Disable typematic rate and typematic delay programming. The system
BIOS will use default value of 2 items and the default is controlled by
the keyboard.
Typematic Rate(Chars/Sec): This is the number of characters that will be re-
peated by a keyboard press. The default is 6.
6 : 6 characters per second.
10: 10 characters per second.
15: 15 characters per second.
24: 24 characters per second.
Typematic Delay(Msec): This determines the time between the first and second
character displayed, when holding a key. The default is 250.
250 : 250msec.
750 : 750 msec.
Security Option: This category allows you to limit access to the system and
Setup, or just to Setup. The default value is Setup.
System: The system will not boot and the access to Setup will be denied if the
correct password is not entered at the prompt.
Setup : The system will boot, but the access to Setup will be denied if the correct
password is not entered at the prompt.
8 : 8 characters per second.
12: 12 characters per second.
20: 20 characters per second.
30: 30 characters per second.
500 : 500 msec.
1000: 1000 msec.
BIOS
Page 4-5