EPOX EP-MVP3G-M User Manual page 26

BIOS
Enabled : Activates automatically when the system boots up causing a warning
message to appear when any attempt to access the boot sector or
hard disk partition table.
Disabled :No warning message to appear when any attempt to access the boot
sector or hard disk partition table.
CPU Internal Cache / External Cache: These two categories speed up memory
access. However, it depends on CPU/chipset design. The default value is Enabled.
If your CPU is without Internal Cache then this item "CPU Internal Cache" will not
be shown.
Enabled : Enable cache.
Disabled : Disable cache.
Quick Power On Self Test:This category speeds up Power On Self Test (POST)
after you power on the computer. If it is set to Enable, BIOS will shorten or skip
some checking items during POST.
Enabled : Enable quick POST.
Disabled: Normal POST.
Boot Sequence:This category determines which drive is searched first for
the O/S(Operating System).The default value is A,C.
A,C : The system will search for floppy disk drive first then hard disk drive.
C,A : The system will search for hard disk drive first then floppy disk drive.
Swap Floppy Drive: This will swap your physical drive letters A&B if you are
using two floppy disks. The default value is Disabled.
Enabled : Floppy A & B will be swapped under the O/S.
Disabled : Floppy A & B will be not swapped.
Boot Up Floppy Seek: During Power-On-Self-Test (POST), BIOS will determine
if the installed floppy drive is 40 or 80 tracks. Only 360K type is 40 tracks while
760K, 1.2M and 1.44M are all 80 tracks. The default value is Enabled.
Enabled : BIOS searches for floppy disk drive to determine if it is 40 or 80 tracks.
Note that BIOS cannot tell from 720K, 1.2M or 1.44M drive type as
they are all 80 tracks.
Disabled: BIOS will not search for the type of floppy disk drive by track number.
Page 4-4
EP-MVP3G-M/2/5