Adding Interfaces To Switched Ports - RuggedCom RuggedBackbone RX1500 User Manual

5. IP Network Interfaces
The length of time in seconds during which addresses generated from the prefix remain preferred.
The default value is 604800.
Off Link
Indicates that advertisement makes no statement about on-link or off-link properties of the prefix.
No Autoconfig
Indicates to hosts on the local link that the specified prefix cannot be used for IPv6 autoconfiguration.
Set Router Address Flag
Indicates to hosts on the local link that the specified prefix contains a complete IP address by setting
the R flag.
This screen is accessible after adding an IPv6 Prefix under the Neighbor Discovery. To display the
forms, navigate to ip/{interface}/ipv6/nd/prefix.

5.3. Adding Interfaces to Switched Ports

For switched ports, you create routable interfaces by configuring VLANs. VLANs are created either
implicitly or explicitly. There are four locations in the web user interface where VLAN interfaces are
created implicitly, and one location where they are created explicitly:
Explicit/Implicit
Table 5.2. Locations For Creating VLAN Interfaces
The procedure below is an example of how to create explicit VLAN interfaces.
ROX™ v2.2 User Guide
Implicit
Implicit
Implicit
Implicit
Explicit
Location in the Web User Interface
interface/switch/{port}
interface/trunks
switch/mcast-filtering/static-mcast-table
switch/mac-table/static-mac-table
switch/vlans/static-vlan
81 RuggedBackbone™ RX1500