Simple Network Setup With The Default Ipv4 Addresses; Configuring An Ip Address - RuggedCom RuggedBackbone RX1500 User Manual

4. Basic Network Configuration
Figure 4.2. Configuring an IP Address
Procedure 4.1. Configuring an IP Address
1. Enter Edit Private mode.
2. Navigate to ip/interface/ipv4.
3. To delete an existing IP address, click the
4. Click Add address. The Key settings form appears.
5. In the IPaddress field, type the new IP address.
6. Click Commit.
7. Click Exit Transaction.
To create additional interfaces, see

4.1.2. Simple Network Setup with the Default IPv4 Addresses

This section describes how to set up a simple network using the factory default IPv4 address.
ROX™ v2.2 User Guide
delete icon.
Section 5.3, "Adding Interfaces to Switched
73
Ports".
RuggedBackbone™ RX1500