Table of Contents
Advertisement
3
If you want to make the VTL Manager page the first page that appears
when you access the REO GUI, select the VTL Manager option.
4
Click Apply.
5
Continue the configuration process by entering the logon information
described in the next section.
Configuring Logon Information
Using the Logon Information section, you can change your logon name
and password, which Overland recommends that you do during the
initial configuration process. If you choose to keep Administrator as your
logon name, Overland strongly recommends that you change the
password to protect your network from unauthorized users.
1
In the right pane, scroll down below the System Information section to
locate the Logon Information section, and enter the following in case-
sensitive format:
!
!
!
2
Click Apply.
3
Continue the configuration process by entering the e-mail information
described in the next section.
Configuring Alerts
The REO continuously monitors its performance and routinely checks for
failures. If you use the messaging options, an e-mail message or Simple
Network Management Protocol (SNMP) trap (or both) is sent whenever
the Status of a RAID volume becomes anything other than OK. Each
alert that is sent reports the status of all volumes on the appliance.
Configuring E-Mail Messaging
1
In the right pane, scroll down below the Logon Information section to
locate the E-mail Notification section, and enter the following:
!
!
User Name. (required) Enter a new logon name using up to 30
alphanumeric characters (do not use colons or spaces). You must use
an upper- or lowercase alphabetical character for the first character
(you can use a through z or A through Z).
Password. (optional) Enter a new password using up to 30
alphanumeric characters (do not use spaces or Ctrl-key characters).
Retype Password. Enter the password again.
SMTP Server IP Address. Using dotted decimal notation, enter the
IP address of your incoming mail server.
From Address. Enter the e-mail address from which the alert will be
sent. This address must use the same domain as the mail server
specified for SMTP Server IP Address.
Configuring Logon Information
Setup Guide
!
47
Advertisement
Table of Contents
