Table of Contents
Advertisement
5
Configuring the Software
Environment
CHAPTER
Step 1
Step 2
Step 3
Step 4
Step 5
Step 6
Step 7
Step 8
Entering or Verifying the Gateway Address and
Management Port Information
1
The main steps involved in configuring the management environment
include:
Entering (or verifying) gateway and Management Port information.
Entering the GbE Data Port information.
Entering system information.
Configuring logon information.
Configuring alerts.
Setting the applicable time-zone information.
Connecting the appliance to the application and backup servers or SAN
for the backup servers.
Installing software client drivers or storage adapters for iSCSI access on
systems involved in the backup process.
The images shown in the following sections were captured on a Windows
system. The screens might appear slightly different if you are using a
UNIX-based system.
The Default Gateway is the IP address that provides entrance into the
network to which the REO is assigned. The Management Port connects
the appliance to the management system, which you use for network
management on the LAN.
Important:
The Management Port and Data Port must be on separate
subnets.
In your Web browser on the management system for the appliance, enter
the applicable IP address to access the REO GUI.
!
If you are using the default configuration and your system is connected
to Data Port 1, enter
10.0.0.1
.
Configuring the Software Environment
!
43
Advertisement
Table of Contents
