System Information; Logon Information; E-Mail Notification; Snmp Configuration - Overland Storage REO 4600 User Manual

REO 4600 User Guide

System Information

System Name. Enter up to 16 characters to name the appliance. You can use a mixture of
letters, numbers, and hyphens (–). Overland recommends that you change the default
name, especially if you use multiple appliances on your network.

Logon Information

Use this section to change your user name and password. We recommend that you change
these settings during the initial configuration process. If you choose to keep Administrator
as your user name, we strongly recommend that you change the password to protect the
appliance from unauthorized access.
IMPORTANT: Both the user name and the password are case-sensitive.
• User Name (required). Enter a name using up to 30 alphanumeric characters (do
not use colons or spaces). The first character of the name must be either an upper
(A–Z) or lowercase (a–z) alphabetical character.
• Password (optional but highly recommended). Enter a new password using up to 30
alphanumeric characters (do not use spaces or Ctrl-key characters).
• Retype Password. Enter the new password again.

E-mail Notification

To send an e-mail message automatically to the specified address whenever the Status of
a RAID volume becomes anything other than OK, click Enable to display the
configuration fields, and enter the following information:
• SMTP Server IP Address. Using dotted decimal notation, enter the IP address of
your mail server.
• From Address. Enter the e-mail address from which the alert is sent. This address
must use the same domain as the mail server specified for SMTP Server IP Address.
• Address for all messages. Enter the e-mail address to which all alerts should be
sent (for example, the e-mail address for the network administrator).
• Address for critical messages only. Enter the e-mail address to which only
critical alerts should be sent.
To verify that the messaging system is configured correctly, click Test. If the test e-mail
message is not successfully sent and received, correct the applicable information and
repeat the test.

SNMP Configuration

To receive notifications of device status changes through the Simple Network
Management Protocol (SNMP), click Enable to display the configuration fields, and enter
the following information:
• Read-Only Community String. Enter the name of the string. You can enter up to
256 alphanumeric characters.
IMPORTANT: Because "public" is the default string for a large number of network
appliances, we strongly recommend that you change it.
10400253-101 01/2010
©2007-10 Overland Storage, Inc.
Protection OS Options
C-20