Nqa Configuration Examples; Icmp Echo Operation Configuration Example - HP MSR Series Configuration Manual

NQA configuration examples

ICMP echo operation configuration example

Network requirements
As shown in
to Device B through Device C to test the round-trip time.
Figure 38 Network diagram
NQA client
10.1.1.1/24
10.3.1.1/24
Device A
Configuration procedure
# Assign each interface an IP address. (Details not shown.)
# Configure static routes or a routing protocol to make sure the devices can reach each other. (Details not
shown.)
# Create an ICMP echo operation, and specify 10.2.2.2 as the destination IP address.
<DeviceA> system-view
[DeviceA] nqa entry admin test1
[DeviceA-nqa-admin-test1] type icmp-echo
[DeviceA-nqa-admin-test1-icmp-echo] destination ip 10.2.2.2
# Configure 10.1.1.2 as the next hop. The ICMP echo requests are sent through Device C to Device B.
[DeviceA-nqa-admin-test1-icmp-echo] next-hop 10.1.1.2
# Configure the ICMP echo operation to perform 10 probes.
[DeviceA-nqa-admin-test1-icmp-echo] probe count 10
# Specify the probe timeout time for the ICMP echo operation as 500 milliseconds.
[DeviceA-nqa-admin-test1-icmp-echo] probe timeout 500
# Configure the ICMP echo operation to repeat at an interval of 5000 milliseconds.
[DeviceA-nqa-admin-test1-icmp-echo] frequency 5000
Figure 38, configure and schedule an ICMP echo operation from the NQA client Device A
Device C
10.1.1.2/24 10.2.2.1/24
10.3.1.2/24 10.4.1.1/24
Device D
10.2.2.2/24
10.4.1.2/24
Device B
123