Enabling Cwmp; Configuring Acs Attributes - HP MSR Series Configuration Manual

Task

Enabling CWMP

Configuring ACS attributes:

•
Configuring the ACS URL
•
Configuring the ACS username and password
Configuring CPE attributes:
•
Configuring the CPE username and password
•
Configuring the CWMP connection interface
•
Sending Inform messages
•
Configuring the maximum number of attempts made to retry a
connection
•
Configuring the close-wait timer of the CPE
•
Configuring the CPE working mode
•
Specifying an SSL client policy for HTTPS connection to ACS
Enabling CWMP
CWMP configurations can take effect only after you enable CWMP.
To enable CWMP:
Step
1. Enter system view.
2. Enter CWMP view.
3. Enable CWMP.
Configuring ACS attributes
ACS attributes include ACS URL, username and password. When the CPE initiates a connection to the
ACS, the ACS URL, username and password are carried in the connection request. After the ACS receives
Command
system-view
cwmp
cwmp enable
78
Remarks
Required.
Required.
Supports configuration through ACS,
DHCP, and CLI.
Optional.
Supports configuration through ACS,
DHCP, and CLI.
Optional.
Supports configuration through ACS and
CLI.
Optional.
Supports configuration through CLI only.
Optional.
Supports configuration through ACS and
CLI.
Optional.
Supports configuration through CLI only.
Optional.
Supports configuration through CLI only.
Optional.
Supports configuration through CLI only.
Optional.
Supports configuration through CLI only.
Remarks
N/A
N/A
By default, CWMP is disabled.