Configuring Ntp Authentication In Broadcast Mode - HP MSR Series Configuration Manual

Configuring NTP authentication for an active peer
Step
1. Enter system view.
2. Enable NTP authentication.
3. Configure an NTP
authentication key.
4. Configure the key as a trusted
key.
5. Associate the specified key
with the passive peer.
Configuring NTP authentication for a passive peer
Step
1. Enter system view.
2. Enable NTP authentication.
3. Configure an NTP
authentication key.
4. Configure the key as a trusted
key.

Configuring NTP authentication in broadcast mode

Follow these instructions to configure NTP authentication in broadcast mode:
A broadcast client can synchronize to the broadcast server only when you configure all the required
•
tasks on both the broadcast client and server.
• If NTP authentication is not enabled on the client, the broadcast client can synchronize to the
broadcast server no matter whether NTP authentication is enabled or not on the server.
Configuring NTP authentication for a broadcast client
Step
1. Enter system view.
Command
system-view
ntp-service authentication enable
ntp-service authentication-keyid
keyid authentication-mode md5
[ cipher | simple ] value
ntp-service reliable
authentication-keyid keyid
ntp-service unicast-peer
{ ip-address | peer-name }
authentication-keyid keyid
Command
system-view
ntp-service authentication enable
ntp-service authentication-keyid
keyid authentication-mode md5
[ cipher | simple ] value
ntp-service reliable
authentication-keyid keyid
Command
system-view
37
Remarks
N/A
By default, NTP authentication is
disabled.
By default, no NTP authentication
key is configured.
Configure the same authentication
key on the active symmetric peer
and passive symmetric peer.
By default, no authentication key is
configured to be trusted.
You can associate a non-existing
key with a passive peer. To enable
NTP authentication, you must
configure the key and specify it as
a trusted key after associating the
key with the passive peer.
Remarks
N/A
By default, NTP authentication is
disabled.
By default, no NTP authentication
key is configured.
Configure the same authentication
key on the active symmetric peer
and passive symmetric peer.
By default, no authentication key is
configured to be trusted.
Remarks
N/A