Command/Response Table For Sis Commands - Extron electronics DMS 1600 Setup Manual

Command/Response Table for SIS Commands

Command
Create ties
NOTES: • Commands can be entered back-to-back in a string, with no spaces. For example: 1*1!02*02&003*003%.
• The matrix switchers support 1-, 2-, and 3-digit numeric entries (1*1!, 02*02&, or 003*003%).
• The ! tie command, the & tie command, and the % tie command can be used interchangeably.
• The ! read tie command, & read tie command, and the % read tie command can be used interchangeably.
X! X@
to output
Tie input
Example (see Notes, above):
X! X@
to output
Tie input
Example (see Notes, above):
X! X@
to output
Tie input
Example (see Notes, above):
Read output tie
Read output tie
Read output tie
X!
NOTE: = Input number
X@
= Output number
Command
Channel mute commands
Channel mute
Channel unmute
Read channel mute
Global channel mute
Global channel unmute
View output mutes
Save and recall presets
NOTE: If you try to recall a preset that is not saved, the matrix switcher responds with the error code E11.
Save current configuration as a
global preset
Example:
Recall a global preset
Example:
NOTE: X@ = Output number
X#
= Mute
X$
= Global preset number
ASCII Command Response
(host to unit) (unit to host)
X! X@
* ! Out
1*3!
Out03
X! X@
* & Out
10*4&
Out04
X! X@
* % Out
7*5%
Out05
X@ X!]
&
X@ X!]
%
X@ X!]
!
00 – maximum number of inputs for your configuration (00 = untied)
01 – maximum number of outputs for your configuration
ASCII Command Response
(host to unit) (unit to host)
X@
*1B Vmt
X@
*0B Vmt
X@ X#]
B
1*B
Vmt1
0*B
Vmt0
E } X#
1
VM
X$
, Spr
9,
Spr09
X$
. Rpr
5.
Rpr05
01 – (maximum number of outputs for your model)
0 = not muted, 1 = muted
00 – 64
Additional description
X@ X! ]
• In • All Tie input
]
Tie input 1 to output 3.
• In01 • All
X@ X! ]
In RGB Tie input
• •
]
Tie input 10 to output 4.
In10 RGB
• •
X@ X! ]
In Vid Tie input
• •
]
Tie input 7 to output 5.
In07 Vid
• •
X!
Input
X!
Input
X!
Input
Additional description
X@ ]
*1 Mute output
X@ ]
*0 Unmute output
1 = mute on, 0 = mute off.
]
Mute all outputs.
]
Unmute all outputs.
X# X# ] X#
2 n
... Each
output, starting from output 1.
n = the maximum number of outputs for your
configuration.
X$]
Command character is a comma.
]
Save current ties as preset 9.
X$]
Command character is a period.
]
Recall preset 5, which becomes the current
configuration.
X! X@
to output .
X! X@
to output .
X! X@
to output .
X@
is tied to output .
X@
is tied to output .
X@
is tied to output .
X@
(no signal is output).
X@
(signal is output).
response is the mute status of an