Stateless Dhcpv6 Configuration Example - HPE FlexNetwork 10500 Series Configuration Manual

Number: 1
Type : Dynamic
Prefix: 12:34::/48
Preferred lifetime 100 sec, valid lifetime 200 sec
# Verify that the client has created a dynamic DHCPv6 option group for saving configuration
parameters.
[Switch] display ipv6 dhcp option-group 1
DNS server addresses:
Type: Dynamic (DHCPv6 address and prefix allocation)
Interface: Vlan-interface2
2000::FF
Domain name:
Type: Dynamic (DHCPv6 address and prefix allocation)
Interface: Vlan-interface2
example.com
SIP server addresses:
Type: Dynamic (DHCPv6 address and prefix allocation)
Interface: Vlan-interface2
2:2::4
SIP server domain names:
Type: Dynamic (DHCPv6 address and prefix allocation)
Interface: Vlan-interface2
bbb.com

Stateless DHCPv6 configuration example

Network requirements
As shown in
parameters except IPv6 address and IPv6 prefix. Switch B acts as the gateway and advertises RA
messages periodically.
Figure 82 Network diagram
Vlan-int2
Switch A
DHCPv6 client
Configuration procedure
You must configure the DHCPv6 server first before configuring the DHCPv6 client. For information
about configuring DHCPv6 server, see
1. Configure the gateway Switch B.
# Configure an IPv6 address for VLAN-interface 2.
<SwitchB> system-view
[SwitchB] interface vlan-interface 2
[SwitchB-Vlan-interface2] ipv6 address 1::1 64
Figure 82, configure Switch A to use stateless DHCPv6 to obtain configuration
DHCPv6 server
Vlan-int2
1::1/64
Switch B
Gateway
"Configuring the DHCPv6
224
server."