Troubleshooting Dhcp Relay Agent Configuration; Symptom; Analysis; Solution - HPE FlexNetwork 10500 Series Configuration Manual
Layer 3-ip services
Hide thumbs
Also See for FlexNetwork 10500 Series:
- Security command reference (881 pages) ,
- Security configuration manual (702 pages) ,
- Network management and monitoring command reference (423 pages)
Table of Contents
Advertisement
Troubleshooting DHCP relay agent configuration
Symptom
DHCP clients cannot obtain configuration parameters through the DHCP relay agent.
Analysis
Some problems might occur with the DHCP relay agent or server configuration.
Solution
To locate the problem, enable debugging and execute the display command on the DHCP relay
agent to view the debugging information and interface state information.
Check that:
•
DHCP is enabled on the DHCP server and relay agent.
•
The DHCP server has an address pool on the same subnet as the DHCP clients.
•
The DHCP server and DHCP relay agent can reach each other.
•
The DHCP server address specified on the DHCP relay interface connected to the DHCP
clients is correct.
84
Advertisement
Table of Contents
Troubleshooting
