HPE FlexNetwork 10500 Series Configuration Manual page 129

Figure 45 Network diagram
2::2/64
DNS server
Configuration procedure
Before performing the following configuration, make sure that:
•
The device and the host can reach each other.
•
The IPv6 addresses of the interfaces are configured as shown in
1. Configure the DNS server:
The configuration might vary by DNS server. The following configuration is performed on a PC
running Windows Server 2008 R2. Make sure that the DNS server supports IPv6 DNS so that
the server can process IPv6 DNS packets and its interfaces can forward IPv6 packets.
a. Select Start > Programs > Administrative Tools > DNS.
The DNS server configuration page appears, as shown in
b. Right-click Forward Lookup Zones, select New Zone, and then follow the wizard to create
a new zone named com.
Figure 46 Creating a zone
c. On the DNS server configuration page, right-click zone com and select New Host.
IP network
3::1/64
2::1/64
Device
DNS client
1::1/64
host.com
Host
118
Figure 45.
Figure 46.