Dhcpv6 Relay Agent Configuration Task List; Enabling The Dhcpv6 Relay Agent On An Interface - HPE FlexNetwork 10500 Series Configuration Manual

Figure 77 Operating process of a DHCPv6 relay agent
DHCPv6 client
(1)
Solicit (contains a Rapid Commit option)

DHCPv6 relay agent configuration task list

Tasks at a glance
(Required.)
(Required.)
(Optional.) Setting the DSCP value for DHCPv6 packets sent by the DHCPv6 relay agent
(Optional.) Specifying a padding mode for the Interface-ID option
(Optional.) Configuring a DHCPv6 address pool on the DHCPv6 relay agent
(Optional.) Specifying a gateway address for DHCPv6 clients
(Optional.) Enabling the DHCPv6 relay agent to record relay entries
(Optional.) Enabling IPv6 release notification
(Optional.) Enabling client offline detection
(Optional.) Enabling the DHCPv6 relay agent to advertise IPv6 prefixes
(Optional.) Specifying the source IPv6 address for relayed DHCPv6 requests

Enabling the DHCPv6 relay agent on an interface

Step
1. Enter system view.
2. Enter interface view.
3. Enable DHCPv6 relay
agent on the interface.
DHCPv6 relay agent
(4) Reply
Enabling the DHCPv6 relay agent on an interface
Specifying DHCPv6 servers on the relay agent
Command
system-view
interface interface-type
interface-number
ipv6 dhcp select relay
(2) Relay-forward
(3) Relay-reply
208
DHCPv6 server
Remarks
N/A
N/A
By default, the DHCPv6 relay agent
is disabled on the interface.
Do not enable the DHCPv6 relay
agent and DHCPv6 client on the
same interface.