Step
3.
Configure an interface to use
BOOTP for IP address
acquisition.
Displaying and maintaining BOOTP client
Execute display command in any view.
Task
Display BOOTP client information.
BOOTP client configuration example
Network requirements
As shown in
VLAN-interface 10 obtains an IP address from the DHCP server by using BOOTP.
To make the BOOTP client obtain an IP address from the DHCP server, you must perform
configuration on the DHCP server. For more information, see
examples."
Configuration procedure
The following describes the configuration on Switch B, which acts as a client.
# Configure VLAN-interface 10 to dynamically obtain an IP address from the DHCP server.
<SwitchB> system-view
[SwitchB] interface vlan-interface 10
[SwitchB-Vlan-interface10] ip address bootp-alloc
Verifying the configuration
# Display the IP address assigned to the BOOTP client.
[SwitchB] display bootp client
Figure
21, Switch B's port belonging to VLAN 10 is connected to the LAN.
Command
ip address bootp-alloc
Command
display bootp client [ interface interface-type
interface-number ]
105
Remarks
By default, an interface does not
use BOOTP for IP address
acquisition.
"DHCP server configuration