Dynamic Domain Name Resolution Configuration Example - HPE FlexNetwork 10500 Series Configuration Manual

Dynamic domain name resolution configuration example

Network requirements
As shown in
name host and IPv4 address 3.1.1.1/16 in the com domain. Configure dynamic IPv4 DNS and DNS
suffix com on the device so that the device can use domain name host to access the host.
Figure 40 Network diagram
2.1.1.2/16
DNS server
Configuration procedure
Before performing the following configuration, make sure that:
•
The device and the host can reach each other.
•
The IP addresses of the interfaces are configured as shown in
1. Configure the DNS server:
The configuration might vary by DNS server. The following configuration is performed on a PC
running Windows Server 2008 R2.
a. Select Start > Programs > Administrative Tools > DNS.
The DNS server configuration page appears, as shown in
b. Right-click Forward Lookup Zones, select New Zone, and then follow the wizard to create
a new zone named com.
Figure 40, configure the DNS server to store the mapping between the host's domain
1.1.1.1/16
2.1.1.1/16
Device
DNS client
IP network
3.1.1.1/16
host.com
Host
114
Figure 40.
Figure 41.