Verifying The Configuration - HPE FlexNetwork 10500 Series Configuration Manual

[SwitchB-Vlan-interface2] ipv6 address 3001::2/64
[SwitchB-Vlan-interface2] quit
# Configure an IPv6 static route with destination IPv6 address 2001::/64 and next hop address
3001::1.
[SwitchB] ipv6 route-static 2001:: 64 3001::1
3. Configure the host:
Enable IPv6 for the host to automatically obtain an IPv6 address through IPv6 ND.
# Display neighbor information for GigabitEthernet 1/0/2 on Switch A.
[SwitchA] display ipv6 neighbors interface gigabitethernet 1/0/2
Type: S-Static
IPv6 address
FE80::215:E9FF:FEA6:7D14
2001::15B:E0EA:3524:E791
The output shows that the IPv6 global unicast address that Host obtained is
2001::15B:E0EA:3524:E791.

Verifying the configuration

# Display the IPv6 interface settings on Switch A. All IPv6 global unicast addresses configured on the
interface are displayed.
[SwitchA] display ipv6 interface vlan-interface 2
Vlan-interface2 current state: UP
Line protocol current state: UP
IPv6 is enabled, link-local address is FE80::20F:E2FF:FE00:2
Global unicast address(es):
3001::1, subnet is 3001::/64
Joined group address(es):
FF02::1
FF02::2
FF02::1:FF00:1
FF02::1:FF00:2
MTU is 1500 bytes
ND DAD is enabled, number of DAD attempts: 1
ND reachable time is 30000 milliseconds
ND retransmit interval is 1000 milliseconds
Hosts use stateless autoconfig for addresses
IPv6 Packet statistics:
InReceives:
InTooShorts:
InTruncatedPkts:
InHopLimitExceeds:
InBadHeaders:
InBadOptions:
ReasmReqds:
ReasmOKs:
InFragDrops:
InFragTimeouts:
OutFragFails:
D-Dynamic O-Openflow
Link Layer
0015-e9a6-7d14 1
0015-e9a6-7d14 1
25829
0
0
0
0
0
0
0
0
0
0
182
R-Rule I-Invalid
VID Interface/Link ID
GE1/0/2
GE1/0/2
State T Age
STALE D 1238
STALE D 1248