Battery Status - Fluke DSP-4100 User Manual

DSP-4000 Series
Users Manual

Battery Status

The test tool displays a message when its battery voltage or the remote battery
voltage is low. Table 2-7 shows the battery status messages and what you should
do if a battery message appears.
When you turn on the remote, the LEDs briefly indicate the battery charge level.
All five LEDs light up if the battery is fully charged; fewer indicate partial charge.
DSP-4300 test tools show the battery status on the Autotest display. If the main
unit is connected to a remote, the test tool also shows the approximate number of
Autotests you can run with the currently-selected test standard. This number is
based on the battery with the lower charge level.
To ensure continued operation while charging the battery, always
connect the ac adapter/charger when the message WARNING
RECHARGEABLE BATTERY VOLTAGE IS LOW appears.
Message Displayed
WARNING RECHARGEABLE BATTERY
VOLTAGE IS LOW.
RECHARGEABLE BATTERY VOLTAGE
IS TOO LOW TO OPERATE.
WARNING REMOTE BATTERY VOLTAGE
IS LOW.
WARNING REMOTE BATTERY
VOLTAGE IS TOO LOW TO OPERATE.
INTERNAL DATA STORAGE BATTERY
VOLTAGE IS LOW.
2-44
Note
Table 2-7. Battery Status Messages
Connect the ac adapter/charger.
Turn the test tool off and connect the ac
adapter/charger. If the tool does not operate
when you turn it on, turn it off again and allow
the battery to charge for about 30 minutes.
Connect the ac adapter/charger to the remote.
Connect the ac adapter/charger to the remote.
You might need to charge the battery for a short
time before the remote will operate.
Have the lithium battery replaced at a Fluke
Networks Service Center.
What You Should Do