Check The Battery Status - Fluke CableAnalyzer DSX-602 User Manual

Check the Battery Status

On a main tester
The battery status icon is in the upper-left corner of the screen:
Battery is full.
Battery is approximately half full.
If the AC adapter is not connected, the red bar shows that
the battery is very low. Connect the AC adapter to charge
the battery and make sure the tester continues to operate.
The red bar also shows if the AC adapter is connected, but the
battery is not installed.
On a remote
The LEDs show the battery status at the end of the power-up
sequence, as shown in Figure 5.
84 % - 100 %
67 % - 83 %
51 % - 66 %
34 % - 50 %
18 % - 33 %
0 % - 17 %
Figure 5. LEDs Show the Remote's Battery Status
Chapter 1: Get Acquainted
AC Adapter and Battery
BK102.EPS
15