Certification And Compliance - Fluke DSP-4100 User Manual

Certification and Compliance

Symbol
The test tool complies with the following standards:
CSA Standards: CAN/CSA-C22.2 No. 1010.1-92 + Amendment 2: 1997 Safety
Requirements for Electrical Equipment for Measurement, Control, and Laboratory
Use, Part 1: General Requirements
Safety: CAN/CSA-C22.2 No. 1010.1-92 + Amendment 2: 1997; Overvoltage
Category II, Pollution degree 2, 30 V. EN61010, Amendments 1,
OVERVOLTAGE (Installation) CATEGORY II, Pollution Degree 2 per IEC1010-
1 refers to the level of Impulse Withstand Voltage protection provided. Equipment
of OVERVOLTAGE CATEGORY II is energy-consuming equipment to be
supplied from the fixed installation. Examples include household, office, and
laboratory appliances.
Test Results Memory for the DSP-4100/4300
The 16 MB multimedia card stores the results of at least 250 Autotests with plot
data included. More results can be stored if plot data is not included. The exact
number of Autotests you can store depends on the number of tests run by the
selected test standard. Compatible memory cards with greater or less capacity can
also be used. A 32 MB card is available as an accessory.
LinkWare software lets you upload Autotest results to a PC from a memory card
installed in the test tool or a memory card reader.
1 MB Flash EPROM allows firmware and test standard updates.
The DSP-4300 includes internal memory that can store the results of at least 250
Autotests with plot data included.
Conforms to relevant European Union directives.
Listed by Canadian Standards Association.
Maintenance and Specifications
Description
8
Specifications
8-23