Enabling and Configuring the Auto Sequence Function
1. Determine the range of cable names you want to use for your Autotests. (Refer
to the previous section.)
2. Turn the rotary switch to SETUP.
3. Use D to highlight the auto increment setting; then press ! Choice.
4. Use D U to highlight Sequence; then press ! Edit ID Seq.
5. Use ! to select the Start ID or End ID field for editing.
6. To add characters to the ID, use the L R U D keys to highlight a character in
the list, then press E.
Use @ Å and # ¶ to move the cursor through the ID.
Use $ Delete to delete characters to the left of the cursor.
7. Press S when you are finished; then press E.
When necessary, you can edit the cable ID when you save an Autotest. See
Chapter 3 for information on saving Autotest results with the auto sequence
function enabled.
Selecting a List of Downloaded IDs (DSP-4300)
On a DSP-4300 test tool you can select cable IDs from lists created with LinkWare
software and saved on a memory card. See the online help or "Getting Started"
under Help on the LinkWare menu for details.
To select a downloaded list as the source for cable IDs, proceed as follows:
1. Put a memory card that holds one or more cable IDs lists into the test tool.
2. Turn the rotary switch to SETUP.
3. Use D U to highlight the auto increment setting; then press !Choice.
4. Use D U to highlight Cable ID List. To view the lists available on
the memory card, press ! Select ID List.
5. Use D U to highlight the list you want to use; then press E. The selected
list appears when you save an Autotest.
Getting Started
Configuring the Test Tool
2
2-39