Remote Requirements For Cable Tests - Fluke DSP-4100 User Manual

Table 4-1. Remote Requirements for Cable Tests
Test
Autotest
Wire Map
NEXT,
NEXT@REMOTE
ELFEXT
Length
Impedance
Attenuation
Resistance
RL, RL@REMOTE
ACR,
ACR@REMOTE
PSACR,
PSACR@REMOTE
PSNEXT,
PSNEXT@REMOTE
PSELFEXT
HDTDR
HDTDX Analyzer
Impulse Noise
Coaxial tests
Traffic Monitor
Required.
Required.
Recommended for NEXT; required for NEXT@REMOTE.
Required. Test available only in Autotest mode.
Optional. Without a remote, the limit and pass/fail result are not
shown.
Optional.
Required.
Optional. Without a remote, the resistance of cable pairs is reported
as "open", assuming the cable pair is not shorted.
Recommended for RL; required for RL@REMOTE.
Required. Tests available only in Autotest mode.
Recommended for PSNEXT; required for PSNEXT@REMOTE.
Required. Test is available only in Autotest mode.
Optional. Without a remote, the end of the cable is not identified.
Recommended. Without a remote, results from tests on short cables
may be unreliable.
Recommended. Without a remote, test results may not represent the
level of noise present on a terminated cable.
Never used.
Never used.
Running Individual Tests
When to Use a Remote Unit
Remote Unit
4
4-3