Battery Status; Battery Status Display - Fluke CableAnalyzer DSP-4000 Series User Manual

Battery Status

The test tool displays a message when its battery voltage or the remote battery
voltage is low. Table 2-7 shows the battery status messages and what you should
do if a battery message appears.
To ensure continued operation while charging the battery, always
connect the ac adapter/charger when the message WARNING
RECHARGEABLE BATTERY VOLTAGE IS LOW appears.
Message Displayed
WARNING RECHARGEABLE BATTERY
VOLTAGE IS LOW.
RECHARGEABLE BATTERY VOLTAGE
IS TOO LOW TO OPERATE.
WARNING REMOTE BATTERY VOLTAGE
IS LOW.
WARNING REMOTE BATTERY
VOLTAGE IS TOO LOW TO OPERATE.
INTERNAL DATA STORAGE BATTERY
VOLTAGE IS LOW.

Battery Status Display

To see the charge level of the main unit's NiMH battery, turn the rotary switch to
SPECIAL FUNCTIONS; then select Battery Status. To see the charge
level of the remote's battery, connect the remote to the main unit; then use ! to
toggle the display.
Note
Table 2-7. Battery Status Messages
Connect the ac adapter/charger.
Turn the test tool off and connect the ac
adapter/charger. If the tool does not operate
when you turn it on, turn it off again and allow
the battery to charge for about 30 minutes.
Connect the ac adapter/charger to the remote.
Connect the ac adapter/charger to the remote.
You might need to charge the battery for a short
time before the remote will operate.
Have the lithium battery replaced at a Fluke
Networks Service Center.
Getting Started
Battery Status
What You Should Do
2
2-41