Value 1 To 4 Display; Decimal Places 1 To 4 - Endress+Hauser Levelflex FMP55 Operating Instructions Manual

Operating menu

Value 1 to 4 display

Navigation
Description
Selection
Factory setting

Decimal places 1 to 4

Navigation
Description
Selection
Factory setting
Additional information
10) can not be selected for the ' V alue 1 display" parameter.
11) Visibility depends on order options or device settings
162
 Setup → Advanced setup → Display → Value 1 display
Select the measured value that is shown on the local display.
10)
• None
• Level linearized
• Distance
• Interface linearized
• Interface distance
• Thickness upper layer
11)
• Current output 1
• Measured current
• Current output 2
• Terminal voltage
• Electronic temperature
• Measured capacitance
• Analog output adv. diagnostics 1
• Analog output adv. diagnostics 2
For interface measurements and one current output
• Value 1 display: Interface linearized
• Value 2 display: Level linearized
• Value 3 display: Thickness upper layer
• Value 4 display: Current output 1
For interface measurements and two current outputs
• Value 1 display: Interface linearized
• Value 2 display: Level linearized
• Value 3 display: Current output 1
• Value 4 display: Current output 2
 Setup → Advanced setup → Display → Decimal places 1
Select the number of decimal places for the display value.
• x
• x.x
• x.xx
• x.xxx
• x.xxxx
x.xx
The setting does not affect the measuring or computational accuracy of the device.
Levelflex FMP55 HART


Endress+Hauser