Failure Current; Output Current 1 To 2 - Endress+Hauser Levelflex FMP55 Operating Instructions Manual

Levelflex FMP55 HART
Additional information

Failure current

Navigation
Prerequisite
Description
User entry
Factory setting

Output current 1 to 2

Navigation
Description
Endress+Hauser
Meaning of the options
• Min.
The current output adopts the value of the lower alarm level according to the Current
span parameter (→  151).
• Max.
The current output adopts the value of the upper alarm level according to the Current
span parameter (→  151).
• Last valid value
The current remains constant at the last value it hat before the error occurred.
• Actual value
The output current follows the actual measured value; the error is ignored.
• Defined value
The output current assumes the value defined in the Failure current parameter
(→  153).
The error behavior of other output channels is not influenced by these settings but is
defined in separate parameters.
 Setup → Advanced setup → Curr.output 1 to 2 → Failure current
Failure mode (→  152) = Defined value
Enter current output value in alarm condition.
3.59 to 22.5 mA
22.5 mA
 Setup → Advanced setup → Curr.output 1 to 2 → Output curr. 1 to 2
Displays calculated output current.
Operating menu

153