Levelflex FMP55 HART
Endress+Hauser
16.4.6
"Simulation" submenu
The Simulation submenu is used to simulate specific measuring values or other
conditions. This helps to check the correct configuration of the device and connected
control units.
Conditions which can be simulated
Condition to be simulated
Specific value of a process variable
Specific value of the output current
Specific state of the switch output
Existence of an alarm
Existence of a specific diagnostic message
Associated parameters
• Assign measurement variable (→ 187)
• Process variable value (→ 187)
• Current output simulation (→ 188)
• Value current output (→ 188)
• Switch output simulation (→ 188)
• Switch status (→ 189)
Device alarm simulation (→ 189)
Diagnostic event simulation (→ 189)
Operating menu
185
Need help?
Do you have a question about the Levelflex FMP55 and is the answer not in the manual?