Memory Position Recall - Jeep commander 2008 Owner's Manual

128 UNDERSTANDING THE FEATURES OF YOUR VEHICLE
11. Select Remote Linked to Memory in the Electronic
Vehicle Information Center (EVIC) and enter Yes or
select Use Factory Settings from the EVIC and enter
Yes . Refer to "Electronic Vehicle Information Center
(EVIC) — Customer Programmable Features" in Section
4 for more information.
12. Repeat the above steps to set the next memory
position, using the other numbered memory button, or to
link another Remote Keyless Entry transmitter to
memory.

Memory Position Recall

NOTE: The vehicle must be in PARK to recall memory
positions. If a recall is attempted when the vehicle is not
in PARK, a message will be displayed in the Electronic
Vehicle Information Center (EVIC).
To recall the memory settings for driver one, press
memory button number 1 on the driver's door, or the
UNLOCK button on the Remote Keyless Entry transmit-
ter linked to memory position 1.
To recall the memory setting for driver two, press
memory button number 2 on the driver's door, or the
UNLOCK button on the Remote Keyless Entry transmit-
ter linked to memory position 2.
A recall can be cancelled by pressing any of the memory
buttons on the drivers door during a recall (S, 1, or 2).
When a recall is cancelled, the driver's seat, driver's
mirror, and the pedals stop moving. A delay of one
second will occur before another recall can be selected.