To Deactivate; To Resume Speed; To Vary The Speed Setting - Jeep commander 2008 Owner's Manual

146 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

To Deactivate

A soft tap on the brake pedal, pulling the speed control
lever towards you, or normal brake pressure while
slowing the vehicle will deactivate speed control without
erasing the set speed memory. Pressing the ON/OFF
button or turning off the ignition switch erases the set
speed memory.

To Resume Speed

To resume a previously set speed, push the RESUME
ACCEL lever up and release. Resume can be used at any
speed above 30 mph (48 km/h) for 3.7L and 4.7L engines,
and 25 mph (40 km/h) for 5.7L engines.

To Vary The Speed Setting

When the speed control is ON, speed can be increased by
pushing up and holding RESUME ACCEL. Release the
lever when the desired speed is reached, and the new
speed will be set.
Tapping RESUME ACCEL once will result in a 2 mph (3
km/h) (3.7L and 4.7L engines) or a 1 mph (2 km/h) (5.7L
engine) speed increase. Each time the lever is tapped,
speed increases so that tapping the lever three times will
increase speed by 6 mph (10 km/h) (3.7L and 4.7L
engines) or 3 mph (5 km/h) (5.7L engine).
To decrease speed while speed control is ON, push down
and hold SET DECEL. Release the lever when the desired
speed is reached, and the new speed will be set.
Tapping the SET DECEL button once will result in a 1
mph (2 km/h) speed decrease. Each time the button is
tapped, speed decreases.
NOTE: The Speed Control system has been designed to
shut down if multiple speed control switch functions are
operated simultaneously in order to ensure proper op-
eration. If this occurs, the system can be reactivated by
pushing the speed control switch ON/OFF button and
re-setting the desired vehicle SET speed.