Table of Contents
Advertisement
304 STARTING AND OPERATING
NEUTRAL Shift Procedure
1. Key ON, engine off.
2. Vehicle stopped, with foot on brake.
3. Place transmission into NEUTRAL.
4. Hold down the NEUTRAL "pin" switch (with a pen,
etc.) for four seconds until the LED lamp by the switch
starts to blink indicating shift in progress. The lamp will
stop blinking (stay on solid) when the NEUTRAL shift is
complete. A "4WD SYSTEM IN NEUTRAL" message will
display on the EVIC (Electronic Vehicle Information
Center). Refer to "Electronic Vehicle Information Center
(EVIC)" in Section 4 of this manual.
Neutral Switch
5. Repeat Steps 1 to 4 to shift out of NEUTRAL.
NOTE: If shift conditions/interlocks are not met, a
"CHECK SHIFT PROCEDURES" message will flash from
the EVIC (Electronic Vehicle Information Center). Refer
to "Electronic Vehicle Information Center (EVIC)" in
Section 4 of this manual.
Advertisement
Chapters
Table of Contents
