Jeep commander 2008 Owner's Manual page 89

88 UNDERSTANDING THE FEATURES OF YOUR VEHICLE
The following are general phone to UConnect system
pairing instructions:
• Press the PHONE button to begin.
• After the Ready prompt and the following beep, say
Setup Phone Pairing.
• When prompted, after the beep, say Pair a Phone and
follow the audible prompts.
• You will be asked to say a four-digit Personal Identi-
fication Number (PIN), which you will later need to
enter into your cellular phone. You can enter any
four-digit PIN. You will not need to remember this PIN
after the initial pairing process.
• For identification purposes, you will be prompted to
give the UConnect system a name for your cellular
phone. Each cellular phone that is paired should be
given a unique phone name.
• You will then be asked to give your cellular phone a
priority level between 1 and 7, with 1 being the highest
priority. You can pair up to seven cellular phones to
your UConnect system. However, at any given time,
only one cellular phone can be in use, connected to
your UConnect system. The priority allows the
UConnect system to know which cellular phone to
use if multiple cellular phones are in the vehicle at the
same time. For example, if priority 3 and priority 5
phones are present in the vehicle, the UConnect
system will use the priority 3 cellular phone when you
make a call. You can select to use a lower priority
cellular phone at any time (refer to Advanced Phone
Connectivity in this section).
Dial by Saying a Number
• Press the PHONE button to begin.
• After the Ready prompt and the following beep, say
Dial.