Electronic Speed Control - If Equipped; Electronic Speed Control Operation - Jeep commander 2008 Owner's Manual

144 UNDERSTANDING THE FEATURES OF YOUR VEHICLE
Press the top of the switch to move the pedals forward
(away from the driver).
• The pedals can be adjusted with the ignition OFF.
• The pedals can be adjusted while driving.
• The pedals cannot be adjusted when the vehicle is in
REVERSE (R) or when the Speed Control is ON. A
message will be displayed in the Electronic Vehicle
Information Center (EVIC) if the pedals are attempted
to be adjusted when the system is locked out ("Ad-
justable Pedal Disabled — Cruise Control Engaged" or
"Adjustable Pedal Disabled — Vehicle In Reverse").
Refer to Electronic Vehicle Information Center (EVIC)
in Section 4 for more information.
CAUTION!
Do not place any article under the adjustable pedal's
or impede its ability to move as it may cause damage
to the pedal controls. Pedal travel may become lim-
ited if movement is stopped by an obstruction in the
adjustable pedal's path.
ELECTRONIC SPEED CONTROL — IF EQUIPPED
When engaged, this device takes over accelerator opera-
tions at speeds greater than 30 mph (48 km/h) for 3.7L
and 4.7L engines, and 25 mph (40 km/h) for 5.7L engines.

Electronic Speed Control Operation

The speed control lever is located on the right side of the
steering wheel.