To Disable A Transmitter Linked To Memory; Easy Entry/Exit Seat - Jeep commander 2008 Owner's Manual

To Disable A Transmitter Linked to Memory

1. Turn the ignition switch to the LOCK position, and
remove the key.
2. Press and release memory button number 1. The
system will recall any memory settings stored in position
1. Wait for the system to complete the memory recall
before continuing to step 3.
3. Press and release the memory S (SET) button located
on the driver's door.
4. Within five seconds, press and release memory button
1 on the driver's door.
5. Within five seconds, press and release the UNLOCK
button on the Remote Keyless Entry transmitter.
To disable another transmitter linked to either memory
position, repeat steps 1 through 5 for each transmitter.
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 129
NOTE: Once programmed, all transmitters linked to
memory can be easily enabled or disabled at one time.
Refer to Remote Linked to Memory under Electronic
Vehicle Information Center (EVIC) — Customer Pro-
grammable Features in Section 4 for more information.

Easy Entry/Exit Seat

This feature provides automatic driver's seat positioning
which will enhance driver mobility out of and into the
vehicle.
There are two possible Easy Entry/Exit adjustments
available:
• The seat cushion will move rearward approximately
2.5 in (60 mm), if the starting position of the seat is
greater than or equal to 2.67 in (68 mm) forward of the
rear seat stop when the key is removed from the
ignition switch. The seat will then move forward
approximately 2.5 in (60 mm) when the key is placed
into the ignition and turned out of the LOCK position.
3