Jeep commander 2008 Owner's Manual page 304

Shifter T-Handle
4WD LOW to 4WD HI
With the vehicle at speeds of 0 to 3 mph (0 to 5 km/h),
key ON or engine running, shift the transmission into
NEUTRAL, and raise the transfer case T-handle. The
STARTING AND OPERATING 303
"4WD LOW" indicator light in the instrument cluster,
will flash and go out when the shift is complete. Release
the T-handle.
NOTE: If shift conditions/interlocks are not met, or a
transfer case motor temperature protection condition
exists, a "CHECK SHIFT PROCEDURES" message will
flash from the EVIC (Electronic Vehicle Information Cen-
ter). Refer to "Electronic Vehicle Information Center
(EVIC)" in Section 4 of this manual.
NOTE: Shifting into or out of 4WD LOW is possible
with the vehicle completely stopped, however difficulty
may occur due to the mating clutch teeth not being
properly aligned. Several attempts may be required for
clutch teeth alignment and shift completion to occur. The
preferred method is with the vehicle rolling 0 to 3 mph (0
to 5 km/h). If the vehicle is moving faster than 3 mph (5
km/h), the transfer case will not allow the shift.
5