Table of Contents
Advertisement
4
5
Operations
Powering On the Switcher
Follow these steps to power on the SW2 DP:
1.
2.
3.
4.
Selecting an Input
To switch an input to the output, press the desired input button on the front panel (ensure
that auto-input switching is not enabled). The LED corresponding to the selected input
button lights.
•
•
You can also select an input using SIS commands (see the
on page 19. Front panel input selection is disabled when auto-input switching is in effect.
HDCP status LEDs —
Inputs: Each input has a numbered HDCP LED. If the connected source is HDCP
•
encrypted, the corresponding input LED lights.
Output: The Output HDCP LED lights if the connected output device has been
•
authenticated.
NOTES:
•
HDCP is re-authenticated on the output whenever a new input is selected.
•
The LEDs do not light if the source does not require HDCP encryption or if
the display device connected to the output is not HDCP compliant.
Config port — Connect a USB cable (USB A to mini B) between your computer and
this female USB mini B port to configure and control the switcher via SIS commands
and to update the firmware.
Connect all input devices and the output to the switcher rear panel connectors (see
Rear Panel Features
on page 4 for information on the rear panel connections).
Power on the output device.
Plug the power supply into the 2-pole captive screw power connector on the rear panel.
The unit performs a self-test, during which the front panel Auto Switch and Input
•
LEDs each blink once in sequence from left to right. When the self-test completes,
the LED for the most recently selected input remains lit.
Depending on the DIP switch setting, the switcher either reads the stored EDID
•
information or applies the default EDID.
Power on the input devices.
To determine the current configuration, check the front panel input LEDs. The one that
is lit indicates the selected input. The LED remains lit until a new input is selected.
Only one input can be switched to the output at a time.
Input Selection commands
SW2 DP • Operation
13
13
Advertisement
Table of Contents
