Extron electronics SW2 DP User Manual page 34

11. If this is the only device to which you are uploading firmware, click
switcher information is added to the
and the window closes.
Add Device
12. If you will be uploading the firmware to multiple SW2 DP switchers that are
connected to your computer, do the following:
a. Click . Your first device is added to the
Add Next
window, and the
Loader
b. For each additional device you want to add to the
repeat steps 5 through
c. For the last device, click
the window.
Add Device
Figure 18. Firmware Loader Screen with an SW2 DP Added
13. If you want to remove a device from the
a. Click on the names of the devices to be deleted, to highlight them.
b. From the menu, select
Edit
c.
On the
Remove Devices
desired, then click
To remove all devices from the field, select
14. Click . The following indicators on the
Begin
progress of the update (see
The
• Transfer Time
The
• Total Progress
In the panel, the Progress column displays an incrementing percentage
• Devices
and another progress bar. The Status column displays
panel of the
Devices
window remains open.
Add Device
9, beginning on page 22, then click
(instead of
Add Add Next
section, do the following:
Devices
Remove Selected Devices
window, select or deselect any devices on the list as
.
Remove
Remove All Devices
Firmware Loader
figure 19 on the next page):
panel shows the remaining and elapsed time for the update.
panel displays a progress bar with
SW2 DP • Remote Configuration and Control
. The
Add
window
Firmware Loader
panel of the
Devices Firmware
window,
Firmware Loader
.
Add Next
) to add the device and to close
.
from the menu.
Edit
window show the
above it.
Uploading...
.
Uploading
26 26 26