Table of Contents
Advertisement
5.
Drill 3/32 inch (2 mm) diameter pilot holes, 1/4 inch (6.3 mm) deep, into the mounting
surface at the marked screw locations.
6.
Insert #8 wood screws into the four pilot holes. Tighten each screw into the mounting
surface until slightly less than 1/4 inch of the screw head protrudes.
7.
Align the centers of the slots in the brackets with the mounting screws and place the
unit against the surface, with the screw heads through the bracket slots.
8.
Slide the unit slightly forward or back, then tighten all four screws to secure it in place.
SW2 DP • Reference Information
31
31
31
31
Advertisement
Table of Contents
Need help?
Do you have a question about the SW2 DP and is the answer not in the manual?
Questions and answers