Page 2
In no event will Extron Electronics be liable for direct, indirect, Reparaciones/mantenimiento • Solicitar siempre los servicios técnicos de personal or consequential damages resulting from any defect in this product even if Extron calificado.
............... A-6 All trademarks mentioned in this manual are the properties of their respective owners. 68-460-02 Rev B Printed in the USA 08 02 www.camboard.de Tel. 07131 911201 ce-info@camboard.de SW2 VGA DA2 AF R • Table of Contents Fax 07131 911203...
Table of Contents, cont’d SW2 VGA DA2 AF R Chapter One Introduction About this Manual About the SW2 VGA DA2 AF R Features www.camboard.de Tel. 07131 911201 ce-info@camboard.de SW2 VGA DA2 AF R • Table of Contents Fax 07131 911203...
About this Manual SW2 VGA DA2 AF R This manual contains information about Extron’s SW2 VGA DA2 AF R switcher and details on how to operate and configure it. About the SW2 VGA DA2 AF R The SW2 VGA DA2 AF R is a full rack width two-input VGA switcher with two buffered outputs and 300 MHz (-3dB) video bandwidth.
The screws for installing the adapter plates are built into the plates, so no additional screws will be needed. To install and set up the SW2 VGA DA2 AF R for operation, Adapter plate installation must be performed follow these steps: by authorized service personnel only.
Attach the switcher to the desk with the provided wood screws, as shown in the following illustration. www.camboard.de Tel. 07131 911201 ce-info@camboard.de SW2 VGA DA2 AF R • Installation and Operation SW2 VGA DA2 AF R • Installation and Operation Fax 07131 911203...
Under-desk mounting Attach the under-desk mounting brackets to the SW2 VGA DA2 AF R with the six provided machine screws, as shown in the under-desk mounting diagram. Hold the switcher with attached brackets against the mounting surface.
Sleeve (s) See Warning Balanced Output Ring Sleeve (s) Ring Wiring the audio output connector www.camboard.de Tel. 07131 911201 ce-info@camboard.de SW2 VGA DA2 AF R • Installation and Operation SW2 VGA DA2 AF R • Installation and Operation Fax 07131 911203...
(projectors, monitors, speakers), contact closure controller, If both inputs have an active sync signal present, the SW2 VGA DA2 AF R switcher, and input devices highest input, input 2, will be used, and the input 2 (computers, audio sources).
If the switcher is in manual switch mode, one of the input indicator LEDs should light on the front panel of the SW2 VGA DA2 AF R. If the switcher is in auto-switching mode and there is no active incoming sync signal detected, the input indicator LEDs will not light.
Page 12
Frequency response ....20 Hz to 20 kHz, ±0.05dB Rack mount ........Yes, with included brackets, and furniture mountable with optional brackets www.camboard.de Tel. 07131 911201 ce-info@camboard.de SW2 VGA DA2 AF R • Specifications SW2 VGA DA2 AF R • Specifications Fax 07131 911203...
Page 13
26-173-01 Included Parts SY 15 HDM-RGBHVF (15-pin HD VGA male to 5 BNC female) 26-397-01 Each order for the SW2 VGA DA2 AF R includes the following items: Included parts SW2 VGA DA2 AF R Rack mounting bracket kit Two-space blank AAP (2) 3.5 mm, 5-pole captive screw connectors...
A variety of optional architectural adapter plates for pass-through connections may be ordered for the switcher. The SW2 VGA DA2 AF R can hold up to two (2) adapter plates. The following configurations of adapters could be installed in either interface: •...
Page 15
Vertrieb von CAMBOARD Electronics Accessories and Part Numbers www.camboard.de Tel. 07131 911201 ce-info@camboard.de SW2 VGA DA2 AF R • Accessories and Part Numbers SW2 VGA DA2 AF R • Accessories and Part Numbers Fax 07131 911203...
Page 16
Vertrieb von CAMBOARD Electronics Accessories and Part Numbers www.camboard.de Tel. 07131 911201 ce-info@camboard.de A-10 SW2 VGA DA2 AF R • Accessories and Part Numbers Fax 07131 911203...
Need help?
Do you have a question about the SW2 VGA DA2 AF R and is the answer not in the manual?
Questions and answers