Table of Contents
Advertisement
Figure 5.
Found New Hardware Wizard Opening Screen
3.
Click
. On the next screen, select the
Next
radio button, then click
(Recommended)
Figure 6.
Selecting the Radio Button to Install the USB Driver Automatically
Your computer locates the driver needed for it to communicate with the SW2 DP via the
USB port and loads it to its hard drive.
4.
When the Completed screen appears, click
NOTE: This wizard appears only the first time you connect the SW2 DP to each
USB port. You do not see the wizard again unless you connect the switcher to a
different USB port on your computer.
5.
Configure the switcher as desired using SIS commands (see the
Configuration and Control
commands).
Install the software automatically
(you do not need to insert a disc).
Next
to close the wizard.
Finish
section, beginning on page 17, for information on available
Remote
SW2 DP • Installation
7
Advertisement
Table of Contents
Need help?
Do you have a question about the SW2 DP and is the answer not in the manual?
Questions and answers