Table of Contents
Advertisement
Enabling Auto-input Switching
You can set up the SW2 DP to automatically select the active connected input based on
the active Main Link signal. If both inputs are active, input 1 is selected. When auto-input
switching is in effect, the green Auto Switch LED on the front panel lights and the front panel
input selection buttons are disabled.
To enable auto-input switching:
1.
2.
3.
T S
P U
I N
2
S
4.
P R
2 D
S W
1
R
W E
Auto-input switching remains in effect as long as the jumper wire connects the two pins and
P O
V
X
1 2
M A
A
- -
the 5-pole captive screw plug is attached to the Remote connector.
Insert the provided 5-pole captive screw plug into the Remote connector on the
switcher rear panel.
Cut a small piece of wire to use as a jumper.
Insert the ends of the wire into slots 4 and 5 of the captive screw plug, shorting pins 4
and 5 together.
I D
E D
D E
I D
E D
E
U T
O R
S T
T P
O U
S T
Figure 7.
Remote Connector with Jumper
Use a small screwdriver to tighten the two screws above pin slots 4 and 5 of the plug,
so that the jumper wire ends remain securely in place.
T E
M O
R E
T O
A U
2
- 2 3
R S
T
U L
G
F A
R X
T X
E D
O R
SW2 DP • Installation
8
Advertisement
Table of Contents
