Table of Contents
Advertisement
HalfRack6inchRackShelf
4.
Install the shelf in the rack.
6" Deep Rack Shelf
Front false
faceplate
uses 2
screws.
Use 2 mounting holes on
opposite corners.
Figure 21.
Mounting an SW2 DP Switcher on a Standard 9.5-inches Deep
Rack Shelf
Back of the rack mounting
The SW2 DP can also be mounted vertically to the front or rear rack supports, using the
optional MBB 100 Back of the Rack Mounting Kit as follows:
1.
If rubber feet were previously attached to the bottom of the unit, remove them.
2.
Remove the two screws from each side of the switcher. Retain the screws for possible
later reassembly.
3.
Attach the brackets to the sides of the unit, using the longer screws included in the
mounting kit.
Figure 22.
Attaching the Back of the Rack Mounting Brackets
1/2 Rack Width Front False
Faceplate
(2) 4-40 x 3/16"
Screws
SW2 DP • Reference Information
29
29
29
29
Advertisement
Table of Contents
Need help?
Do you have a question about the SW2 DP and is the answer not in the manual?
Questions and answers