1u, two input, dual output vga-qxga and stereo audio switcher with front and rear panel inputs (2 pages)
Summary of Contents for Extron electronics SW2 VGA DA2 A
Page 1
User’s Manual SW2 VGA DA2 A, SW2 VGA DA2 AF 2-Input Switchers with 2 Buffered Outputs and Audio Extron Electronics, USA Extron Electronics, Europe Extron Electronics, Asia Extron Electronics, Japan 1230 South Lewis Street Beeldschermweg 6C 135 Joo Seng Road, #04-01...
Page 2
Precautions FCC Class A Notice Safety Instructions • English Warning This symbol is intended to alert the user of important Power sources • This equipment should be operated only from the power source indicated on the product. This equipment is intended to be used with a main operating and maintenance (servicing) instructions Note: This equipment has been tested and found to comply with the limits for a power system with a grounded (neutral) conductor.
Table of Contents, cont’d SW2 VGA DA2 A /AF Chapter One Introduction About this Manual About the SW2 VGA DA2 A /AF Features SW2 VGA DA2 A /AF • Table of Contents...
About this Manual SW2 VGA DA2 A /AF This manual contains information about the Extron SW2 VGA DA2 A and SW2 VGA DA2 AF switchers and details on how to operate and configure them. About the SW2 VGA DA2 A /AF...
Installation Overview diagonally opposite corners, as shown in the following illustration. To install and set up the SW2 VGA DA2 A /AF for operation, follow these steps: 1U Universal Rack Shelf Turn all of the equipment off. Make sure that the video...
Attach the through-desk mounting brackets switcher, adjust the height by sliding the switcher up or (part #70-077-02) to the SW2 VGA DA2 A /AF with the down, and retighten the screws. four provided machine screws, as shown in the through- desk mounting diagram on the next page.
Audio output connector — Balanced or unbalanced audio can be output via this 3.5 mm, 5-pole captive screw connector. The audio output cable should be wired in the following illustration. SW2 VGA DA2 A /AF • Installation and Operation SW2 VGA DA2 A /AF • Installation and Operation...
(projectors, monitors, speakers), contact closure controller, If both inputs have an active sync signal present, the SW2 VGA DA2 A /AF switcher, and input devices highest input, input 2, will be used, and the input 2 (computers, audio sources).
LEDs should light on the front panel of the A (L N IT Cable SW2 VGA DA2 A /AF. If the switcher is in autoswitching 2 VG mode and there is no active incoming sync signal detected, /R E the input indicator LEDs will not light.
Installation and Operation, cont’d SW2 VGA DA2 A /AF Appendix Specifications, Accessories and Part Numbers Specifications Included Parts Accessories Cables Adapters SW2 VGA DA2 A /AF • Installation and Operation 2-12...
Page 12
General Max. rise/fall time ....... 40 ns Power Polarity .......... Positive or negative (follows input) SW2 VGA DA2 A /AF’s external power supply 100 VAC to 240 VAC, 50/60 Hz, external, Audio autoswitchable; to 12 VDC, 1 A power Gain ..........Unbalanced output: 0 dB; balanced output:...
Page 13
Enclosure type ......Metal Enclosure dimensions Accessories Part number SW2 VGA DA2 A /AF ....1.0" H x 8.75" W x 3.0" D 2.5 cm H x 22.2 cm W x 7.6 cm D Through-desk mounting bracket kit 70-077-02 (Depth excludes connectors.)
Page 14
Adapters Part number Mac/VGA adapter 26-340-01 Mac HV/VGA adapter 26-340-02 SY-VGA/XGA-6’ (15-pin HD VGA male to 5 BNC male) 26-173-01 SW2 VGA DA2 A /AF • Accessories and Part Numbers SW2 VGA DA2 A /AF • Accessories and Part Numbers...
Page 15
Accessories and Part Numbers, cont’d SW2 VGA DA2 A /AF • Accessories and Part Numbers...
Need help?
Do you have a question about the SW2 VGA DA2 A and is the answer not in the manual?
Questions and answers