Table of Contents
Advertisement
SE-1201 Electrocardiograph User Manual
Definitions of corresponding pins:
Pin
1
2
3
4
3) USB Socket 1/USB Socket 2/USB Socket 3
Only the USB equipment recommended by the manufacturer can be connected to the
USB socket 1/2.
Definitions of corresponding pins:
Pin
1
2
1. Accessory equipment connected to the analog and digital interfaces must be certified
according to the respective IEC/EN standards (e.g. IEC/EN 60950 for data
processing equipment and IEC/EN 60601-1 for medical equipment). Furthermore all
configurations shall comply with the valid version of the standard IEC/EN 60601-1-1.
Therefore anybody, who connects additional equipment to the signal input or output
connector to configure a medical system, must make sure that it complies with the
requirements of the valid version of the system standard IEC/EN 60601-1-1. If in
doubt, consult our technical service department or your local distributor.
2. If multiple instruments are connected to a patient, the sum of the leakage currents
may exceed the limits given in the IEC/EN 60601-1 and may pose a safety hazard.
Consult your service personnel.
Signal
Pin
CD DAT3
5
CMD
6
Vss
7
Vcc
8
Signal
+5V
D-
Signal
Pin
CLK
9
Vss
10
DAT0
11
DAT1
CAUTION
Pin
3
4
WARNING
- 15 -
Introduction
Signal
DAT2
CD
WP
Signal
D+
GND
Advertisement
Table of Contents
