Offset Adjustment Procedure - MUTOH Ultima 850 Operation Instructions Manual

Mutoh Ultima Multi-Purpose Cutting Plotter - Operation Instructions

5.4. OFFSET ADJUSTMENT PROCEDURE

In the Ultima you have 3 tools (drag knife, pen and pounce tool) with their own velocity, force, acceleration
and offset (only drag knife) settings. Each user preset holds the settings for these 3 tools.
Notes :
1) Inaccurate offset setting may cause :
In case the offset adjustment routine is aborted, the cutter will continue working with
the value prior to launching the adjustment routine.
To perform an offset, please follow the instructions mentioned below.
Step 1 : Install a knife in the tool head. Please do not forget to select knife in the menu.
Step 2 : Install a sheet of media.
Step 3 : Press the [OFFSET] key. The display will show the following message.
Step 4 : By pressing the [UP] or [DOWN] key select a value.
Step 5 : Press the [ENTER] key to confirm. The display will show the following message.
Step 6 : By pressing the [UP] or [DOWN] key select the "test1" or "test2"
Notes :
Press the [CANCEL] key in case you do not want to perform an offset.
POOR cutting quality.
Difficult weeding.
Offset
Actual 0.50
New 0.50
Calibration base
Test offset:
Cancel = no test
Up = test1
Down = test2
46
AP-75125, Rev 1.3 ; 20/10/04