GE C70 Instruction Manual page 276
Capacitor bank protection
and control system
Hide thumbs
Also See for C70:
- Instruction manual (708 pages) ,
- Communications manual (532 pages) ,
- Instruction manual (546 pages)
Table of Contents
Advertisement
PRODUCT SETUP
CHAPTER 5: SETTINGS
— This setting controls the behavior of the user-programmable pushbutton on message that is
PUSHBTN 1 MESSAGE
programmed in the
and
settings, and the behavior of the user-programmable pushbutton
PUSHBTN 1 ID
PUSHBTN 1 ON TEXT
off message that is programmed in the
and
settings.
PUSHBTN 1 ID
PUSHBTN 1 OFF TEXT
When set to "Disabled", user-programmable pushbutton messages do not display. Otherwise the on message displays
when the user-programmable pushbutton becomes activated, and if in the "Latched" mode the off message displays when
the user-programmable pushbutton becomes deactivated.
When set to "Normal", the duration the message displays is as specified by the
setting.
FLASH MESSAGE TIME
When set to "High Priority", the duration of the off message is as specified by the
setting, but the on
FLASH MESSAGE TIME
message is displayed as long as the user-programmable pushbutton is activated. While activated, target and other
messages are suppressed. To allow front panel keypad operation, when a keypad button is pressed the message is
supressed for 10 seconds.
— If this setting is enabled, each user-programmable pushbutton state change is logged as an
PUSHBUTTON 1 EVENTS
event into the event recorder.
The figures show the user-programmable pushbutton logic.
Figure 5-48: User-programmable pushbutton logic (Sheet 1 of 2)
5
5-110
C70 CAPACITOR BANK PROTECTION AND CONTROL SYSTEM – INSTRUCTION MANUAL
Advertisement
Table of Contents
