Custom Led Labeling - GE C70 Instruction Manual

CHAPTER 4: INTERFACES
User customization of LED operation is of maximum benefit in installations where languages other than English are used
to communicate with operators. See the User-programmable LEDs section in chapter 5 for the settings used to program
the operation of the LEDs on these panels.
Default labels for LED panel 2
The default labels are intended to represent the following:
• GROUP 1...6 — The illuminated GROUP is the active settings group
The relay is shipped with the default label for the LED panel 2. The LEDs, however, are not pre-programmed. To match the
pre-printed label, the LED settings must be entered as shown in the User-programmable LEDs section of chapter 5. The
LEDs are fully user-programmable. The default labels can be replaced by user-printed labels for both panels as explained in
the next section.

4.2.8 Custom LED labeling

4.2.8.1 Enhanced faceplate
The following procedure requires these pre-requisites:
• EnerVista UR Setup software is installed and operational
• The C70 settings have been saved to a settings file
• The UR front panel label cutout sheet (GE part number 1006-0047) has been downloaded from
http://www.gegridsolutions.com/products/support/ur/URLEDenhanced.doc
• Small-bladed knife
To create custom LED labels for the enhanced front panel display:
1. Start the EnerVista UR Setup software.
2. Select the Front Panel Label Designer item from the Online Window or Offline Window area, for example under
C70 CAPACITOR BANK PROTECTION AND CONTROL SYSTEM – INSTRUCTION MANUAL
Figure 4-25: LED panels 2 and 3 (index template)
Figure 4-26: LED panel 2 (default labels)
FRONT PANEL INTERFACE
and printed
4
4-23