GE C70 Instruction Manual page 185

CHAPTER 5: SETTINGS
Setting name Description
Firmware Lock Indicates if the device receives firmware
(via Lock Relay) upgrades. If Enabled and the firmware
upgrade attempt is made, the device denies
the upgrade and displays an error message
that the lock is set. On each firmware upgrade,
this setting goes back to the default.
The Lock Relay setting blocks settings and
firmware updates.
Factory Service When enabled, the device can go into factory
Mode service mode. To enable, Supervisor
authentication is necessary.
Restore to Defaults Sets the device to factory defaults
Supervisor Role When enabled, the Supervisor role is active. To
enable, Administrator authentication is
necessary. When disabled, the Supervisor role
is inactive. To disable, Supervisor
authentication is necessary.
RADIUS user names Ensures that RADIUS user names are not the
same as local/device role names
Password Local/device roles except for Observer are
password-protected. All RADIUS users are
password-protected.
Table 5-5: Security alarm settings
Setting name Description / Details
Failed A threshold number indicating when an alarm
Authentications is set off to indicate too many failed
authentication attempts
Firmware Lock A value indicating if the device can receive a
firmware upgrade. If Enabled and a firmware
upgrade attempt is made, the device alarm
activates. If Disabled, the device alarm does not
activate. On each firmware upgrade this setting
goes back to the default.
Settings Lock A value indicating if the device can accept any
settings changes. If Enabled and a settings
change attempt is made, the device alarm
activates. If Disabled, the device alarm does not
activate.
CyberSentry settings through the front panel
SETTINGS  PRODUCT SETUP  SECURITY
 SECURITY

C70 CAPACITOR BANK PROTECTION AND CONTROL SYSTEM – INSTRUCTION MANUAL
Minimum
Disabled
Disabled
No
Disabled
See RADIUS
server
documents
See the
Password
Requirements
section earlier
in this chapter
LOGIN:

None
 CHANGE LOCAL

 PASSWORDS
 SESSION

 SETTINGS
Maximum Default
Enabled Enabled
Enabled Disabled
Yes No
Enabled Enabled
See
RADIUS
server
document
s
See the Change
following Me1#
password
section for
requireme
nts
Min Max Default
0 99 3
(disabled)
Disabled Enabled Enabled
Disabled Enabled Enabled
Range: Administrator, Engineer, Supervisor,
Operator, Factory (for factory use only), None
See page 5-20
See page 5-21
PRODUCT SETUP
Units Minimum
permission
- Administrator
- Supervisor
(Administrator
when Supervisor
is disabled)
- Administrator
- Administrator to
enable and
Supervisor to
disable
- Administrator
Text The specified
role and
Administrator,
except for
Supervisor,
where it is only
itself
Units Minimum
permissions
- Administrator
- Administrator
- Supervisor
(Administrator if
Supervisor has
been disabled)
5-19
5